For Customer Service, contact the place of purchase to arrange for replacement parts.
2073-LP GMT PARTS AND ASSEMBLY SHEETS
PARTS & ASSEMBLY SHEET
This fixture assembled PO: Date:
Fixture Name: SMYTH 2073-LP GMT
Notice: Please review the Parts List and check for all parts before assembling the fixture. If any
parts
are missing or damaged, please note on this sheet and contact the place of purchase
to arrange for replacement parts.
PARTS LIST
Company Name:______________ Co Account#:__________
below to be filled out by retailer
Mounting Strap
3/4"*1" 1ea
㎜ 1ea
㎜
2ea H38
㎜
2ea
Wire Connectors
Orange 3ea
㎜ 2ea
Nut
16*15 ㎜ 1ea
Canopy 1
L298*W115*H30 ㎜
” Rod Φ 12*L305
6ea
” Rod Φ12*L152㎜
ea
1ea
22*50mm 5ea
Part Needed ______________________________ Quantity _________________________________
Part Needed _____
_________________________ Quantity _________________________________
Reason why (missing, scratched, broken glass, bent, bad finish)
Comments __________________________________________________________________________
FIXTURE ASSEMBLY INSTRUCTIONS
Read and review installation instruction sheet
before assembling the fixture
1. Measure to determine the correct number of
rods needed for proper hanging height. There are
3 optional 12" rods and a 6” rod included
side.
2. To shorten the fixture, trim the wires to the
desired leng
th. Please add at least 8~10 inches to
the desired length when measuring and keep in
mind that you must use at least the 6” rods
3. To lengthen the fixture, add additional rods.
(ROD-12 CDB) are available.
the retailer.
4. Pull the fixture’s wire through the rods.
5. Place Washers (I) between Rod (H) and Frame
(S). Thread Rod (H) into Frame(S) until tight.
6. Place Washers (I) between each rod to
connect.
7. Feed the fixture wire through Canopy (F) and
pull the wires until taut and thread Canopy (F
) into
Rod (H) until tight.
Comments to this Manuals