Golden-lighting 1425-3P WG User Manual download pdf (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.

3. Feed the fixture wires through Top loop (J) and pull the

wires until taut. Then screw Top Loop（J） to the threaded

center column of Frame (M) until tight. .

4. By measuring, determine correct number of links needed

for proper hanging height. To remove any excess chain, use

a pair of pliers to open one link of Chain (K) and discard the

excess chain.

5. Use one Chain Connector (L) to attach one end of the

chain to Top Loop (J). Then close the chain connector.

6. Feed the fixture wires through the chain (every three links)

and pull the wires until taut.

7. Slip Canopy Loop Collar (H) over the chain, then do the

same with the Canopy (G).

8. When ready to complete the installation, use the other

chain connector and attach the other end of the chain to the

Canopy Loop (H). Then close the chain connector.

9. Feed the fixture wires through Canopy Loop (F) and

Nipple (C) and pull until taut.

* You may now install the fixture.

Fig 2

1. Attach Crystal Bobeche (U) by sliding it over the

socket. Then, slide Candle Sleeve (O) into the hole

and straighten.

Note: Please do not attempt to slide Crystal Bobeche

(P) over the chrome Candle Sleeve (O) as it will

scratch and damage the finish of the candle sleeve.

Fig 3

PARTS & ASSEMBLY SHEET

Fixture Name: Sancerre 1425-3P WG

1 2 3

No comments

Golden-lighting 1425-3P WG User Manual Page 2