INSTALLATION INSTRUCTIONS
Fixture Name:
Sancerre 1425-5/9/3P/M1L WG
For Chandelier Light Fixture
7. Unscrew Canopy Loop Collar (H) from Canopy Loop (F). Take Canopy
(G) and pass over Canopy Loop (F). Approximately one half of the canopy
loop exterior threads should be exposed. Adjust until the desired height is
reached. *Canopy Loop Collar (H) should fit snugly on Canopy Loop (F) after
Canopy (G) is installed. Remove Canopy (G) and Canopy Lock Collar (H).
8. Assemble the fixture. Use an assistant or a secure support to hold the
weight of the fixture while you complete the wiring connections.
9.Thread the fixture wires and ground wire of the assembled fixture through
Canopy Loop (F) and Nipple (C) and into the outlet box.
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the yellow bag that
holds all parts. Check that all parts are included as shown in the Parts and
Assembly Sheet.
2. Shut off the power at the circuit breaker and remove the old fixture from
ceiling, including the old mounting strap.
3. Thread Nipple (C) into Canopy Loop (F) until snug.
4. Thread the other end of Nipple (C), with Canopy Loop (F) attached, into
Mounting Strap (D).
5. Place Lock Washer (B) over the end of Nipple (C) which should protrude
through Mounting Strap (D). Thread Hex Nuts (A) onto Nipple (C) until tight.
6. Take this mounting strap assembly and mount it to the ceiling junction box
using Mounting screws (E). Tighten the screws securely with a screw driver.
For Customer Service, contact the place of purchase to arrange for replacement parts.
CONNECTING THE WIRES (Fig 2)
10. Attach the power supply wires to the fixture lead wires by connecting BLACK to
BLACK (or SMOOTH) and WHITE to WHITE (or RIBBED).
11. Attach the GROUND wire (GREEN or COPPER) from the Junction Box and the
fixture Ground Wire to the green Ground Screw on Mounting Bracket (D) or connect
both wires together using the correct size of wire connectors.
NOTE: Twist the wires together in the same direction you twist the wire connector
onto the wires.
12. Tuck these wire connections neatly into the Junction Box.
13. Raise Canopy (G) to the ceiling and secure in place by tightening Canopy Loop
collar (H) into Canopy Loop (F)
14. Install the light bulbs and glass shade as per the fixture assembly sheet.
YOUR INSTALLATION IS NOW
COMPLETE. RETURN POWER TO
THE JUNCTION BOX AND TEST THE
FIXTURE.
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals