Golden-lighting 1323-M1L WG User Manual

Browse online or download User Manual for Lighting Golden-lighting 1323-M1L WG. Golden Lighting 1323-M1L WG User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Assembly Instructions: 1323-M1L WG (Ella)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completelyremovetheoldxturefromtheceiling,includingthe
oldmountingstrap.
Fromthepartsbagremovethemountingstrapassembly.One
endofnipple(F)shouldbeattachedtomountingstrap(A)with
hexnuts(C,D)inplace.Theotherendshouldhavecanopyloop
(H) attached.
Attachmountingstrap(A)tothejunctionboxusingmounting
screws(B)andascrewdriver.Tightensecurely.Unscrewcanopy
loop collar (I) from canopy loop (H). Pass canopy (G) over the
mountedcanopylooptotesttheheight.Approximatelyhalf
ofthecanopyloop’sexteriorthreadsshouldbeexposed,and
thecanopyloopcollarshouldtsnuglyontothecanopyloop.
Removecanopy(G)andadjusttheheightofnipple(F)and
canopyloop(H)untilthedesiredheightisreached.
ASSEMBLING THE FIXTURE
Usedecorativenuts(M)toattachthearmstothexturebody.
Refertothecrystalinstallationsheettohangthecrystals.
HANGING THE FIXTURE
Bymeasuring,determinethecorrectnumberofchainlinks
neededforproperhangingheight.Ifnecessary,useapair
ofplierstoopenandremoveanyexcesschain.Attachone
chain connector (K) to each end of chain (J). Use one of chain
connectors (K) to attach chain (J) to top loop (L) and close the
chainconnector.Feedthexturewiresupthroughthechain
(everythreelinksorso),pullingthewiresuntiltaut.Slidecanopy
loop collar (H) and canopy (G) onto the chain/wire. Use the free
chain connector (K) to attach chain (J) to canopy loop (H).
CONNECTING THE WIRES
Haveanassistantsupportthextureweightwhilecompleting
thewiring.Cutawayexcesswire.Threadthexturewires
throughcanopyloop(H)andnipple(F).Attachthexture’swires
tothepowersupplywiresfromthejunctionbox.Connectblack
toblack(orsmooth);whitetowhite(orribbed);groundtoground
(greenorcopper).Twisttheendsofthewirepairstogether,then
twist on a wire connector. Make sure all twists are in the same
direction.Ifthereisnogroundwire(greenorcopper)fromthe
junctionbox,locategroundscrew(E)onmountingstrap(A)and
wrapthexturegroundwirearoundthegreengroundscrew(E).
Useascrewdrivertosecuregroundscrew(E)ontothemounting
bracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Pushcanopy(G)uptotheceilingandslidecanopyloopcollar(I)
upbeneaththecanopy.Tightlythreadcanopyloopcollar(I)onto
canopy loop (H) to secure canopy (G) in place.
Installbulb(O)inaccordancewiththexture’sspecications.
See the bulb note below. Gently screw bulbshield (P) around the
socket.Donotovertighten.
Bulb Note: Use a tissue or paper towel to hold the bulb and
push down into the socket. Oils and dirt can cause the bulb life
toshorten.Rubbingalcoholisrecommendedforcleaning.
Your installation is now complete. Turn on the power and test
thexture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
A
E
B
D
C
G
I
K
P
L
M
O
N
J
H
F
Page view 0
1 2

Summary of Contents

Page 1

Assembly Instructions: 1323-M1L WG (Ella)IMPORTANT: • ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL. • SHUT OFF POWER SUPPLY AT FU

Page 2 - 1323 Crystal Instructions

AA is a double sided crystal, 50mmPart: PT-CRYSTAL-1323-AAAS is a single sided crystal,50mmPart: PT-CRYSTAL-1323-ASA - crystal dropB - crystal dropC -

Comments to this Manuals

No comments