Golden-lighting 5050-M1L CH User Manual

Browse online or download User Manual for Lighting Golden-lighting 5050-M1L CH. Golden Lighting 5050-M1L CH User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Assembly Instructions: 5050-M1L CH (Danica)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Carefully remove all of the contents from the carton. See the
important notes above. Shut off the power at the circuit breaker
andcompletelyremovetheoldxturefromthewall,including
theoldmountingstrap.
Mountingstrap(B)containsseveralpairsofthreadedholes.Find
thepairofholesthatmatchesthespacingoftheholesonthe
junctionboxandyourxturebackplate.Twoofmountingscrews
(A)shouldbeattachedtomountingstrap(B).Youmayneedto
tightennuts(C)thatholdthesescrewsinplace.Pullthehouse
wiresthroughthecenterofmountingstrap(B).Placemounting
strap(B)overthejunctionboxsothatmountingscrews(A)are
vertical,andinalignmentwiththeholelocationsoncanopy(F).
Securemountingstrap(B)tothejunctionboxwithmounting
screws(D)andascrewdriver.Tightenthescrewssecurely.
Bymeasuring,determinethecorrectamountofdecorative
chain(K)andcablewire(L)neededforproperhangingheight.
Toshortenthexture,trimthewirestothedesiredlengthplus
at least 8 to 10 inches. Unhook and discard any unwanted
decorativechain(K).Putthewirethroughnipple(H)ofcanopy
(F).
CONNECTING THE WIRES
Haveanassistantsupportthextureweightwhilecompleting
thewiring.Cutawayanyexcesswires.Threadthexturewires
throughcanopy(F).Attachthexture’swirestothepower
supplywiresfromthejunctionbox.Connectblacktoblack(or
smooth);whitetowhite(orribbed);groundtoground(greenor
copper).Twisttheendsofthewirepairstogether,thentwiston
a wire connector. Make sure all twists are in the same direction.
Ifthereisnogroundwire(greenorcopper)fromthejunction
box,locategroundscrew(E)onmountingstrap(B)andwrap
thexturegroundwirearoundthegreengroundscrew(E).Use
ascrewdrivertosecuregroundscrew(E)ontothemounting
bracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Pushcanopy(F)uptotheceilingsothatmountingscrews(A)
protrudethroughtheholesincanopy(F).Securecanopy(F)
totheceilingbytightlythreadingdecorativenuts(G)ontothe
screws. Slide shade (J) over socket (I) and secure in place with
socketring(K).
Installthelightbulbs(notincluded)inaccordancewith
thexture’sspecications.Donotexceedthemaximum
recommendedwattage.
Your installation is now complete. Turn on the power and test
thexture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
I
J
K
A
D
B
C
E
L
M
G
F
H
Page view 0
1

Summary of Contents

Page 1 - FINISHING THE INSTALLATION

Assembly Instructions: 5050-M1L CH (Danica)IMPORTANT: • ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL. • SHUT OFF POWER SUPPLY AT

Comments to this Manuals

No comments